Not sure how much you need? Use the guttering parts calculator

Tell us about the job and we'll suggest quantities for the colour and sizes chosen above. This is a starting point only, so please check it against your own drawings and adjust any quantity before ordering.

Lindab Quick Order

Choose your colour and size once and we'll list every matching Lindab part, so you can add everything to your basket in one go and avoid mixing sizes or colours part way through an order.

1 Choose your colour
2 Choose your size (pick gutter size, downpipe size, or both)
Gutter size
Downpipe size
Loading the Lindab range…
How is this worked out? See the diagram
ROOF GROUND 1 = one 3m length 2 joint between lengths 4 stop ends 800mm (600mm on 150mm) 3 Corner (seen from above) joint joint angle 5 angle + 2 joints per corner Return to wall (choose one) A one-piece offset bend 50 or 100mm B conical bend + socket bend one of each 7 6 R 8 9
  • 1
    Gutter lengthsTotal gutter length ÷ 3m, rounded up to whole 3m lengths.
  • 2
    Gutter jointsOne between each pair of lengths along a run, plus 2 at every corner (see 5).
  • 3
    Gutter bracketsOne every 800mm on 100mm and 125mm gutter, every 600mm on 150mm gutter, plus one extra per run to finish the end.
  • 4
    Stop ends2 per run, one at each end of the run.
  • 5
    Corners1 external or internal angle per corner (90° or 135° as chosen) plus 2 gutter joints on each.
  • 6
    Outlets1 per downpipe, to connect the gutter into the downpipe.
  • 7
    Return to wallChoose a one-piece offset bend (50mm or 100mm kick-off) or 1 conical bend + 1 socket bend. 1 set per downpipe.
  • 8
    Downpipe lengths and brackets3m lengths, based on the height of each drop, plus 1 bracket for every metre of drop.
  • 9
    Shoe1 per downpipe, at the bottom.

Worked example

A 12m run of 125mm gutter with 1 external and 1 internal 90° corner and 2 downpipes, each with a 5m drop:

Gutter lengths12m ÷ 3m4
Gutter brackets12m ÷ 0.8m = 15, +1 for the run16
Gutter joints3 between lengths + 2 each on 2 corners7
Stop ends2 per run2
Corner angles1 external + 1 internal, 90°2
Outlets1 per downpipe2
Downpipe lengths5m drop = 2 lengths, × 2 downpipes4
Downpipe brackets5 per drop × 210
Shoes1 per downpipe2

These are starting quantities only. Always check against your own drawings and add spares as needed.

Guide only: quantities are estimates and may not suit your job. You are responsible for checking every quantity, size, colour and fitting against your own drawings and measurements before ordering. We cannot accept responsibility for shortages, surplus or incorrect orders resulting from use of this tool.